User guide

862 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Access Control Lists
41
To show a list of ACLs:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Show from the Action list.
FIGURE 201 Showing a List of ACLs
Configuring a Standard IPv4 ACL
Use the Security > ACL (Configure ACL - Add Rule - IP Standard) page to configure a Standard IPv4
ACL.
CLI References
• “permit, deny (Standard IP ACL)” on page 241
• “show ip access-list” on page 245
• “Time Range” on page 102
Parameters
These parameters are displayed:
• Type – Selects the type of ACLs to show in the Name list.
• Name – Shows the names of ACLs matching the selected type.
• Action – An ACL can contain any combination of permit or deny rules.
• Address Type – Specifies the source IP address. Use “Any” to include all possible addresses,
“Host” to specify a specific host address in the Address field, or “IP” to specify a range of
addresses with the Address and Subnet Mask fields. (Options: Any, Host, IP; Default: Any)
• Source IP Address – Source IP address.
• Source Subnet Mask – A subnet mask containing four integers from 0 to 255, each separated
by a period. The mask uses 1 bits to indicate “match” and 0 bits to indicate “ignore.” The mask
is bitwise ANDed with the specified source IP address, and compared with the address for
each IP packet entering the port(s) to which this ACL has been assigned.
• Time Range – Name of a time range.