User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 41
53-1002581-01
General Commands
4
• Any combination of reload options may be specified. If the same option is re-specified, the
previous setting will be overwritten.
• When the system is restarted, it will always run the Power-On Self-Test. It will also retain all
configuration information stored in non-volatile memory by the copy running-config
startup-config command (See “copy” on page 67).
Example
This example shows how to reset the switch after 30 minutes:
Console(config)#reload in minute 30
***
*** --- Rebooting at January 1 02:10:43 2007 ---
***
Are you sure to reboot the system at the specified time? <y/n>
enable
This command activates Privileged Exec mode. In privileged mode, additional commands are
available, and certain commands display additional information. See “Understanding Command
Modes” on page 32.
Syntax
enable [level]
level - Privilege level to log into the device.
The device has two predefined privilege levels: 0: Normal Exec, 15: Privileged Exec. Enter
level 15 to access Privileged Exec mode.
Default Setting
Level 15
Command Mode
Normal Exec
Command Usage
• “super” is the default password required to change the command mode from Normal Exec to
Privileged Exec. (To set this password, see the enable password command.)
• The “#” character is appended to the end of the prompt to indicate that the system is in
privileged access mode.
Example
Console>enable
Password: [privileged level password]
Console#
Related Commands
disable (43)
enable password (142)