User guide

810 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Creating QoS Policies
39
• Peak Burst Size (BP) – Burst size in bytes. (Range: 0-16000000 at a granularity of 4k
bytes)
The burst size cannot exceed 16 Mbytes.
• Conform – Specifies that traffic conforming to the maximum rate (CIR) will be
transmitted without any change to the DSCP service level.
• Transmit – Transmits in-conformance traffic without any change to the DSCP
service level.
• Exceed – Specifies whether traffic that exceeds the maximum rate (CIR) but is within
the peak information rate (PIR) will be dropped or the DSCP service level will be
reduced.
• Set IP DSCP – Decreases DSCP priority for out of conformance traffic.
(Range: 0-63).
• Drop – Drops out of conformance traffic.
• Violate – Specifies whether the traffic that exceeds the peak information rate (PIR) will
be dropped or the DSCP service level will be reduced.
• Set IP DSCP – Decreases DSCP priority for out of conformance traffic.
(Range: 0-63).
• Drop – Drops out of conformance traffic.
Interface
To configure a policy map:
1. Click Traffic, DiffServ.
2. Select Configure Policy from the Step list.
3. Select Add from the Action list.
4. Enter a policy name.
5. Enter a description.
6. Click Add.
FIGURE 152 Configuring a Policy Map
To show the configured policy maps:
1. Click Traffic, DiffServ.
2. Select Configure Policy from the Step list.
3. Select Show from the Action list.