User guide

704 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Trunk Configuration
33
Interface
To display LACP port counters:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Aggregation Port from the Step list.
3. Select Show Information from the Action list.
4. Click Counters.
5. Select a group member from the Port list.
FIGURE 61 Displaying LACP Port Counters
Displaying LACP Settings and Status for the Local Side
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show Information - Internal)
page to display the configuration settings and operational state for the local side of a link
aggregation.
CLI References
• “show lacp” on page 297
Marker Unknown Pkts Number of frames received that either (1) Carry the Slow Protocols
Ethernet Type value, but contain an unknown PDU, or (2) are addressed
to the Slow Protocols group MAC Address, but do not carry the Slow
Protocols Ethernet Type.
Marker Illegal Pkts Number of frames that carry the Slow Protocols Ethernet Type value, but
contain a badly formed PDU or an illegal value of Protocol Subtype.
TABLE 154 LACP Port Counters (Continued)
Parameter Description