User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 703
53-1002581-01
Trunk Configuration
33
FIGURE 59 Configuring Connection Settings for Dynamic Trunks
To display connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Show from the Action List.
FIGURE 60 Displaying Connection Parameters for Dynamic Trunks
Displaying LACP Port Counters
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show Information - Counters)
page to display statistics for LACP protocol messages.
CLI References
• “show lacp” on page 297
Parameters
These parameters are displayed:
TABLE 154 LACP Port Counters
Parameter Description
LACPDUs Sent Number of valid LACPDUs transmitted from this channel group.
LACPDUs Received Number of valid LACPDUs received on this channel group.
Marker Sent Number of valid Marker PDUs transmitted from this channel group.
Marker Received Number of valid Marker PDUs received by this channel group.