User guide

702 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Trunk Configuration
33
FIGURE 57 Configuring LACP Parameters on a Port
To show the active members of a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Show Member from the Action List.
4. Select a Trunk.
FIGURE 58 Showing Members of a Dynamic Trunk
To configure connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step List.
3. Select Configure from the Action List.
4. Modify the required interface settings. (See “Configuring by Port List” on page 675 for a
description of the interface settings.)
5. Click Apply.