User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 671

53-1002581-01

Displaying Memory Utilization

Use the System > Memory Status page to display memory utilization parameters.

CLI References

• "show memory" on page 58

Parameters

The following parameters are displayed:

• Free Size – The amount of memory currently free for use.

• Used Size – The amount of memory allocated to active processes.

• Total – The total amount of system memory.

Interface

To display memory utilization:

1. Click System, then Memory Status.

FIGURE 25 Displaying Memory Utilization

Resetting the System

Use the System > Reset menu to restart the switch immediately, at a specified time, after a

specified delay, or at a periodic interval.

CLI References

• "reload (Privileged Exec)" on page 44

• "reload (Global Configuration)" on page 40

• "show reload" on page 44

Command Usage

• This command resets the entire system.

• When the system is restarted, it will always run the Power-On Self-Test. It will also retain all

configuration information stored in non-volatile memory by the copy running-config

startup-config command (see "copy" on page 67).