User guide

656 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Managing System Files
32
NOTE
The maximum number of user-defined configuration files is limited only by available flash memory
space.
Interface
To save the running configuration file:
1. Click System, then File.
2. Select Copy from the Action list.
3. Select Running-Config from the Copy Type list.
4. Select the current startup file on the switch to overwrite or specify a new file name.
5. Then click Apply.
FIGURE 13 Saving the Running Configuration
If you replaced a file currently used for startup and want to start using the new file, reboot the
system via the System > Reset menu.
Setting The Start-Up File
Use the System > File (Set Start-Up) page to specify the firmware or configuration file to use for
system initialization.
CLI References
• "whichboot" on page 71
• "boot system" on page 66
Interface
To set a file to use for system initialization:
1. Click System, then File.
2. Select Set Start-Up from the Action list.
3. Mark the operation code or configuration file to be used at startup
4. Then click Apply.