User guide

650 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Displaying Hardware/Software Versions
32
Interface
To configure general system information:
1. Click System, General.
2. Specify the system name, location, and contact information for the system administrator.
3. Click Apply.
FIGURE 8 System Information
Displaying Hardware/Software Versions
Use the System > Switch page to display hardware/firmware version numbers for the main board
and management software, as well as the power status of the system.
CLI References
• "System Management Commands" on page 47
Parameters
The following parameters are displayed:
Main Board Information
• Serial Number – The serial number of the switch.
• Number of Ports – Number of built-in ports.
• Hardware Version – Hardware version of the main board.
• Internal Power Status – Displays the status of the internal power supply.
Management Software Information
• Role – Shows that this switch is operating as Master or Slave.
• EPLD Version – Version number of EEPROM Programmable Logic Device.
• Loader Version – Version number of loader code.
• Operation Code Version – Version number of runtime code.
• Thermal Detector – The first detector is located between the physical layer ASICs on the main
board. The second and third detector are located on right and left side of daughter board.
• Temperature – Temperature at specified thermal detection point.