User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 643
53-1002581-01
Navigating the Web Browser Interface
31
Configure MD
Configure Maintenance Domains 977
Add
Defines a portion of the network for which connectivity faults can
be managed, identified by an MD index, maintenance level, and the MIP
creation method
977
Configure Details
Configures the archive hold time and fault notification settings 977
Show
Shows list of configured maintenance domains 977
Configure MA
Configure Maintenance Associations 981
Add
Defines a unique CFM service instance, identified by its parent MD, the
MA index, the VLAN assigned to the MA, and the MIP creation method
981
Configure Details
Configures detailed settings, including continuity check status and
interval level, cross-check status, and alarm indication signal parameters
981
Show
Shows list of configured maintenance associations 981
Configure MEP
Configures Maintenance End Points 985
Add
Configures MEPs at the domain boundary to provide management access
for each maintenance association
985
Show
Shows list of configured maintenance end points 985
Configure Remote MEP
Configures Remote Maintenance End Points 986
Add
Configures a static list of remote MEPs for comparison against
the MEPs learned through continuity check messages
986
Show
Shows list of configured remote maintenance end points 986
Transmit Link Trace
Sends link trace messages to isolate connectivity faults by
tracing the path through a network to the designated target node
988
Transmit Loopback
Sends loopback messages to isolate connectivity faults by requesting a
target node to echo the message back to the source
989
Transmit Delay Measure
Sends periodic delay-measure requests to a specified MEP within a
maintenance association
991
Show Information
Show Local MEP
Shows the MEPs configured on this device 993
Show Local MEP Details
Displays detailed CFM information about a specified local MEP in the
continuity check database
994
Show Local MIP
Shows the MIPs on this device discovered by the CFM protocol 996
Show Remote MEP
Shows MEPs located on other devices which have been discovered
through continuity check messages, or statically configured in the MEP
database
997
Show Remote MEP Details
Displays detailed CFM information about a specified remote MEP in the
continuity check database
998
Show Link Trace Cache
Shows information about link trace operations launched from this device 999
Show Fault Notification Generator
Displays configuration settings for the fault notification generator 1001
Show Continuity Check Error
Displays CFM continuity check errors logged on this device 1002
TABLE 151 Switch Main Menu (Continued)
Menu Description Page