User guide

514 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
LLDP Commands
24
lldp dot1-tlv pvid
This command configures an LLDP-enabled port to advertise its default VLAN ID. Use the no form
to disable this feature.
Syntax
[no] lldp dot1-tlv pvid
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
The port’s default VLAN identifier (PVID) indicates the VLAN with which untagged or priority-tagged
frames are associated (see the switchport native vlan command).
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv pvid
Console(config-if)#
lldp dot1-tlv vlan-name
This command configures an LLDP-enabled port to advertise its VLAN name. Use the no form to
disable this feature.
Syntax
[no] lldp dot1-tlv vlan-name
Default Setting
Enabled
Command Mode
Interface Configuration (Ethernet, Port Channel)
Command Usage
This option advertises the name of all VLANs to which this interface has been assigned. See
“switchport allowed vlan” on page 382 and “protocol-vlan protocol-group (Configuring Interfaces)”
on page 404.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#no lldp dot1-tlv vlan-name
Console(config-if)#