User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 509
53-1002581-01
LLDP Commands
24
lldp tx-delay
This command configures a delay between the successive transmission of advertisements initiated
by a change in local LLDP MIB variables. Use the no form to restore the default setting.
Syntax
lldp
tx-delay seconds
no lldp
tx-delay
seconds - Specifies the transmit delay. (Range: 1 - 8192 seconds)
Default Setting
2 seconds
Command Mode
Global Configuration
Command Usage
• The transmit delay is used to prevent a series of successive LLDP transmissions during a short
period of rapid changes in local LLDP MIB objects, and to increase the probability that multiple,
rather than single changes, are reported in each transmission.
• This attribute must comply with the following rule:
(4 * tx-delay) ≤
refresh-interval
Example
Console(config)#lldp tx-delay 10
Console(config)#
lldp admin-status
This command enables LLDP transmit, receive, or transmit and receive mode on the specified port.
Use the no form to disable this feature.
Syntax
lldp admin-status {rx-only | tx-only | tx-rx}
no lldp admin-status
rx-only - Only receive LLDP PDUs.
tx-only - Only transmit LLDP PDUs.
tx-rx - Both transmit and receive LLDP Protocol Data Units (PDUs).
Default Setting
tx-rx
Command Mode
Interface Configuration (Ethernet, Port Channel)