User guide

500 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
MVR for IPv6
23
Console#
show mvr6 associated-profile
This command shows the profiles bound the specified domain.
Syntax
show mvr6 [domain domain-id] associated-profile
domain-id - An independent multicast domain. (Range: 1-5)
Default Setting
Displays profiles bound to all MVR domains.
Command Mode
Privileged Exec
Example
The following displays the profiles bound to domain 1:
Console#show mvr6 domain 1 associated-profile
Domain ID : 1
MVR Profile Name Start IPv6 Addr. End IPv6 Addr.
-------------------- ------------------------- -------------------------
rd FF00::1 FF00::9
Console#
show mvr6 interface
This command shows MVR configuration settings for interfaces attached to the MVR VLAN.
Syntax
show mvr6 [domain domain-id] interface
domain-id - An independent multicast domain. (Range: 1-5)
TABLE 118 show mvr6 - display description
Field Description
MVR Proxy Switching Shows if MVR proxy switching is enabled
MVR Robustness Value Shows the number of reports or query messages sent when proxy switching is
enabled
MVR6 Domain An independent multicast domain.
MVR6 Config Status Shows if MVR is globally enabled on the switch.
MVR6 Running Status Indicates whether or not all necessary conditions in the MVR environment are
satisfied. (Running status is true as long as MVR Status is enabled, and the
specified MVR VLAN exists, and a source port with a valid link has been configured
(using the mvr6 type command.)
MVR6 Multicast VLAN Shows the VLAN used to transport all MVR multicast traffic.
MVR6 Upstream Source IP The source IP address assigned to all upstream control packets.