User guide

480 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
MVR for IPv4
23
mvr robustness-value
This command configures the expected packet loss, and thereby the number of times to generate
report and group-specific queries. Use the no form to restore the default setting.
Syntax
mvr robustness-value value
no mvr robustness-value
value - The robustness used for all interfaces. (Range: 1-255)
Default Setting
1
Command Mode
Global Configuration
Command Usage
• This command is used to set the number of times report messages are sent upstream when
changes are learned about downstream groups, and the number of times group-specific
queries are sent to downstream receiver ports.
• This command only takes effect when MVR proxy switching is enabled.
Example
Console(config)#mvr robustness-value 5
Console(config)#
Related Commands
mvr proxy-switching (479)
mvr upstream-source-ip
This command configures the source IP address assigned to all MVR control packets sent
upstream on all domains or on a specified domain. Use the no form to restore the default setting.
Syntax
mvr [domain domain-id] upstream-source-ip source-ip-address
no mvr [domain domain-id] upstream-source-ip
domain-id - An independent multicast domain. (Range: 1-5)
source-ip-address – The source IPv4 address assigned to all MVR control packets sent
upstream.
Default Setting
All MVR reports sent upstream use a null source IP address
Command Mode
Global Configuration