User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 471
53-1002581-01
IGMP Filtering and Throttling
23
ip igmp filter (Interface Configuration)
This command assigns an IGMP filtering profile to an interface on the switch. Use the no form to
remove a profile from an interface.
Syntax
[no] ip igmp filter profile-number
profile-number - An IGMP filter profile number. (Range: 1-4294967295)
Default Setting
None
Command Mode
Interface Configuration
Command Usage
• The IGMP filtering profile must first be created with the ip igmp profile command before being
able to assign it to an interface.
• Only one profile can be assigned to an interface.
• A profile can also be assigned to a trunk interface. When ports are configured as trunk
members, the trunk uses the filtering profile assigned to the first port member in the trunk.
Example
Console(config)#interface ethernet 1/1
Console(config-if)#ip igmp filter 19
Console(config-if)#
ip igmp max-groups
This command sets the IGMP throttling number for an interface on the switch. Use the no form to
restore the default setting.
Syntax
ip igmp max-groups number
no ip igmp max-groups
number - The maximum number of multicast groups an interface can join at the same
time. (Range: 1-1023)
Default Setting
1023
Command Mode
Interface Configuration (Ethernet)