User guide

466 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Static Multicast Routing
23
Number of Leaves Sent : 0
Console#
Static Multicast Routing
This section describes commands used to configure static multicast routing on the switch.
ip igmp snooping vlan mrouter
This command statically configures a (Layer 2) multicast router port on the specified VLAN. Use the
no form to remove the configuration.
Syntax
[no] ip igmp snooping vlan vlan-id mrouter interface
vlan-id - VLAN ID (Range: 1-4093)
interface
ethernet unit/port
unit - Unit identifier. (Range: 1)
port - Port number. (Range: 1-12)
port-channel channel-id (Range: 1-12)
Default Setting
No static multicast router ports are configured.
Command Mode
Global Configuration
TABLE 107 show ip igmp snooping statistics vlan query - display description
Field Description
Querier IP Address The IP address of the querier on this interface.
Querier Expire Time The time after which this querier is assumed to have expired.
General Query Received The number of general queries received on this interface.
General Query Sent The number of general queries sent from this interface.
Specific Query Received The number of specific queries received on this interface.
Specific Query Sent The number of specific queries sent from this interface.
Number of Reports Sent The number of reports sent from this interface.
Number of Leaves Sent The number of leaves sent from this interface.
TABLE 108 Static Multicast Interface Commands
Command Function Mode
ip igmp snooping vlan mrouter Adds a multicast router port GC
show ip igmp snooping mrouter Shows multicast router ports PE