User guide

450 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
IGMP Snooping
23
ip igmp snooping proxy-reporting
This command enables IGMP Snooping with Proxy Reporting. Use the no form to restore the default
setting.
Syntax
[no] ip igmp snooping proxy-reporting
ip igmp snooping vlan vlan-id proxy-reporting {enable | disable}
no ip igmp snooping vlan vlan-id proxy-reporting
vlan-id - VLAN ID (Range: 1-4093)
enable - Enable on the specified VLAN.
disable - Disable on the specified VLAN.
Default Setting
Global: Enabled
VLAN: Based on global setting
Command Mode
Global Configuration
Command Usage
• When proxy reporting is enabled with this command, the switch performs “IGMP Snooping with
Proxy Reporting” (as defined in DSL Forum TR-101, April 2006), including last leave, and query
suppression. Last leave sends out a proxy query when the last member leaves a multicast
group, and query suppression means that specific queries are not forwarded from an
upstream multicast router to hosts downstream from this device.
• If the IGMP proxy reporting is configured on a VLAN, this setting takes precedence over the
global configuration.
Example
Console(config)#ip igmp snooping proxy-reporting
Console(config)#
ip igmp snooping querier
This command enables the switch as an IGMP querier. Use the no form to disable it.
Syntax
[no] ip igmp snooping querier
Default Setting
Enabled
Command Mode
Global Configuration