User guide

380 Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Configuring VLAN Interfaces

Default Setting

By default only VLAN 1 exists and is active.

Command Mode

VLAN Database Configuration

Command Usage

• no vlan vlan-id deletes the VLAN.

• no vlan vlan-id name removes the VLAN name.

• no vlan vlan-id state returns the VLAN to the default state (i.e., active).

• You can configure up to 4093 VLANs on the switch.

NOTE

The switch allows 4093 user-manageable VLANs.

Example

The following example adds a VLAN, using VLAN ID 105 and name RD5. The VLAN is activated by

default.

Console(config)#vlan database

Console(config-vlan)#vlan 105 name RD5 media ethernet

Console(config-vlan)#

Related Commands

show vlan (387)

Configuring VLAN Interfaces

TABLE 85 Commands for Configuring VLAN Interfaces

Command Function Mode

interface vlan Enters interface configuration mode for a specified VLAN IC

switchport acceptable-frame-types Configures frame types to be accepted by an interface IC

switchport allowed vlan Configures the VLANs associated with an interface IC

switchport forbidden vlan Configures forbidden VLANs for an interface IC

switchport gvrp Enables GVRP for an interface IC

switchport ingress-filtering Enables ingress filtering on an interface IC

switchport mode Configures VLAN membership mode for an interface IC

switchport native vlan Configures the PVID (native VLAN) of an interface IC

switchport priority default Sets a port priority for incoming untagged frames IC

vlan-trunking Allows unknown VLANs to cross the switch IC