User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 373
53-1002581-01
Chapter
20VLAN Commands
A VLAN is a group of ports that can be located anywhere in the network, but communicate as
though they belong to the same physical segment. This section describes commands used to
create VLAN groups, add port members, specify how VLAN tagging is used, and enable automatic
VLAN registration for the selected interface.
TABLE 82 VLAN Commands
Command Group Function
GVRP and Bridge Extension
Commands
Configures GVRP settings that permit automatic VLAN learning; shows
the configuration for bridge extension MIB
Editing VLAN Groups Sets up VLAN groups, including name, VID and state
Configuring VLAN Interfaces Configures VLAN interface parameters, including ingress and egress
tagging mode, ingress filtering, PVID, and GVRP
Displaying VLAN Information Displays VLAN groups, status, port members, and MAC addresses
Configuring IEEE 802.1Q Tunneling Configures 802.1Q Tunneling (QinQ Tunneling)
Configuring L2CP Tunneling
*
* These functions are not compatible.
Configures Layer 2 Control Protocol (L2CP) tunneling, either by
discarding, processing, or transparently passing control packets across a
QinQ tunnel
Configuring VLAN Translation
*
Maps VLAN ID between customer and service provider for networks that
do not support IEEE 802.1Q tunneling
Configuring Port-based Traffic
Segmentation
Configures traffic segmentation for different client sessions based on
specified downlink and uplink ports
Configuring Protocol-based VLANs Configures protocol-based VLANs based on frame type and protocol
Configuring IP Subnet VLANs Configures IP Subnet-based VLANs
Configuring MAC Based VLANs Configures MAC-based VLANs
Configuring Voice VLANs Configures VoIP traffic detection and enables a Voice VLAN