User guide

370 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
ERPS Commands
19
Default Setting
5 minutes
Command Mode
ERPS Configuration
Command Usage
If the switch goes into ring protection state due to a signal failure, after the failure condition is
cleared, the RPL owner will start the wait-to-restore timer and wait until it expires to verify that the
ring has stabilized before blocking the RPL and returning to the Idle (normal operating) state.
Example
Console(config-erps)#wtr-timer 10
Console(config-erps)#
show erps
This command displays status information for all configured rings, or for a specified ring
Syntax
show erps [domain ring-name]
ring-name - Name of a specific ERPS ring. (Range: 1-32 characters)
Command Mode
Privileged Exec
Example
This example displays a summary of all the ERPS rings configured on the switch.
Console#show erps
ERPS Status : Enabled
Number of ERPS Domains : 1
Domain State MEL Enabled West East RPL Owner Ctrl VLAN
------------ ---------- --- ------- -------- -------- --------- ---------
rd1 Idle 0 Yes Eth 1/12 Eth 1/10 Yes 100
rd2 Protection 0 Yes Eth 1/3 Eth 1/4 No 200
Console#
TABLE 80 show erps - summary display description
Field Description
ERPS Status Shows whether ERPS is enabled on the switch.
Number of ERPS Domains Shows the number of ERPS rings configured on the switch.
Domain Displays the name of each ring followed by a brief list of status information