User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 361
53-1002581-01
ERPS Commands
19
Related Commands
enable (362)
erps domain
This command creates an ERPS ring and enters ERPS configuration mode for the specified domain.
Use the no form to delete a ring.
Syntax
[no] erps domain name
name - Name of a specific ERPS ring. (Range: 1-12 characters)
Default Setting
None
Command Mode
Global Configuration
Command Usage
Up to 6 ERPS rings can be configured on the switch.
Example
Console(config)#erps domain r&d
Console(config-erps)#
control-vlan
This command specifies a dedicated VLAN used for sending and receiving ERPS protocol
messages. Use the no form to remove the Control VLAN.
Syntax
[no] control-vlan vlan-id
vlan-id - VLAN ID (Range: 1-4093)
Default Setting
None
Command Mode
ERPS Configuration
Command Usage
• Configure one control VLAN for each ERPS ring. First create the VLAN to be used as the control
VLAN (vlan, page 379), add the ring ports for the east and west interface as tagged members
to this VLAN (switchport allowed vlan, page 382), and then use the control-vlan command to
add it to the ring.