User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 283
53-1002581-01
Interface Commands
12
Default Setting
Shows all interfaces.
Command Mode
Normal Exec, Privileged Exec
Command Usage
If no interface is specified, information on all interfaces is displayed.
Example
This example shows the configuration setting for port 1.
Console#show interfaces switchport ethernet 1/1
Information of Eth 1/1
Broadcast Threshold : Enabled, 500 packets/second
Multicast Threshold : Disabled
Unknown Unicast Threshold : Disabled
LACP Status : Disabled
Ingress Rate Limit : Disabled, 1000M bits per second
Egress Rate Limit : Disabled, 1000M bits per second
VLAN Membership Mode : Hybrid
Ingress Rule : Disabled
Acceptable Frame Type : All frames
Native VLAN : 1
Priority for Untagged Traffic : 0
GVRP Status : Disabled
Allowed VLAN : 1(u)
Forbidden VLAN :
802.1Q-tunnel Status : Disable
802.1Q-tunnel Mode : NORMAL
802.1Q-tunnel TPID : 8100(Hex)
Console#
TABLE 64 show interfaces switchport - display description
Field Description
Broadcast
Threshold
Shows if broadcast storm suppression is enabled or disabled; if enabled it also shows the
threshold level (page 270).
Multicast Threshold Shows if multicast storm suppression is enabled or disabled; if enabled it also shows the
threshold level (page 270).
Unknown-unicast
Threshold
Shows if unknown unicast storm suppression is enabled or disabled; if enabled it also
shows the threshold level (page 270).
LACP Status Shows if Link Aggregation Control Protocol has been enabled or disabled (page 292).
Ingress/Egress Rate
Limit
Shows if rate limiting is enabled, and the current rate limit (page 311).
VLAN Membership
Mode
Indicates membership mode as Trunk or Hybrid (page 384).
Ingress Rule Shows if ingress filtering is enabled or disabled (page 383).
Acceptable Frame
Type
Shows if acceptable VLAN frames include all types or tagged frames only (page 381).
Native VLAN Indicates the default Port VLAN ID (page 385).