User guide

Brocade 6910 Ethernet Access Switch Configuration Guide 251
53-1002581-01
MAC ACLs
11
show ipv6 access-group
This command shows the ports assigned to IPv6 ACLs.
Command Mode
Privileged Exec
Example
Console#show ipv6 access-group
Interface ethernet 1/2
IPv6 standard access-list david in
Console#
Related Commands
ipv6 access-group (250)
MAC ACLs
The commands in this section configure ACLs based on hardware addresses, packet format, and
Ethernet type. To configure MAC ACLs, first create an access list containing the required permit or
deny rules, and then bind the access list to one or more ports.
access-list mac
This command adds a MAC access list and enters MAC ACL configuration mode. Use the no form to
remove the specified ACL.
Syntax
[no] access-list mac acl-name
acl-name – Name of the ACL. (Maximum length: 16 characters, no spaces or other special
characters)
Default Setting
None
Command Mode
Global Configuration
TABLE 60 MAC ACL Commands
Command Function Mode
access-list mac Creates a MAC ACL and enters configuration mode GC
permit, deny Filters packets matching a specified source and destination address,
packet format, and Ethernet type
MAC-ACL
mac access-group Binds a MAC ACL to a port IC
show mac access-group Shows port assignments for MAC ACLs PE
show mac access-list Displays the rules for configured MAC ACLs PE