User guide

198 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Network Access (MAC Address Authentication)
10
network-access aging
Use this command to enable aging for authenticated MAC addresses stored in the secure MAC
address table. Use the no form of this command to disable address aging.
Syntax
[no] network-access aging
Default Setting
Disabled
Command Mode
Global Configuration
Command Usage
• Authenticated MAC addresses are stored as dynamic entries in the switch’s secure MAC
address table and are removed when the aging time expires. The address aging time is
determined by the mac-address-table aging-time command.
• This parameter applies to authenticated MAC addresses configured by the MAC Address
Authentication process described in this section, as well as to any secure MAC addresses
authenticated by 802.1X, regardless of the 802.1X Operation Mode (Single-Host, Multi-Host, or
MAC-Based authentication as described on page 179).
• The maximum number of secure MAC addresses supported for the switch system is 1024.
Example
Console(config-if)#network-access aging
Console(config-if)#
network-access mode
mac-authentication
Enables MAC authentication on an interface IC
network-access port-mac-filter Enables the specified MAC address filter IC
mac- authentication
intrusion-action
Determines the port response when a connected host fails MAC
authentication.
IC
mac- authentication
max-mac-count
Sets the maximum number of MAC addresses that can be
authenticated on a port via MAC authentication
IC
clear network-access Clears authenticated MAC addresses from the address table PE
show network-access Displays the MAC authentication settings for port interfaces PE
show network-access
mac-address- table
Displays information for entries in the secure MAC address table PE
show network-access mac-filter Displays information for entries in the MAC filter tables PE
TABLE 50 Network Access Commands (Continued)
Command Function Mode