User guide

124 Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

SNMP Commands

• Based on the default settings used in RFC 3014, a notification log can contain up to 256

entries, and the entry aging time is 1440 minutes. Information recorded in a notification log,

and the entry aging time can only be configured using SNMP from a network management

station.

• When a trap host is created with the snmp-server host command, a default notify filter will be

created as shown in the example under the show snmp notify-filter command.

Example

This example first creates an entry for a remote host, and then instructs the switch to record this

device as the remote host for the specified notification log.

Console(config)#snmp-server host 10.1.19.23 batman

Console(config)#snmp-server notify-filter A1 remote 10.1.19.23

Console#

show nlm oper-status

This command shows the operational status of configured notification logs.

Command Mode

Privileged Exec

Example

Console#show nlm oper-status

Filter Name: A1

Oper-Status: Operational

Console#

show snmp notify-filter

This command displays the configured notification logs.

Command Mode

Privileged Exec

Example

This example displays the configured notification logs and associated target hosts.

Console#show snmp notify-filter

Filter profile name IP address

---------------------------- ----------------

A1 10.1.19.23

Console#