User guide

116 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
SNMP Commands
6
snmp-server group
This command adds an SNMP group, mapping SNMP users to SNMP views. Use the no form to
remove an SNMP group.
Syntax
snmp-server group groupname
{v1 | v2c | v3 {auth | noauth | priv}}
[read readview] [write writeview] [notify notifyview]
no snmp-server group groupname
groupname - Name of an SNMP group. (Range: 1-32 characters)
v1 | v2c | v3 - Use SNMP version 1, 2c or 3.
auth | noauth | priv - This group uses SNMPv3 with authentication, no authentication, or
with authentication and privacy. See “Simple Network Management Protocol” on page 929
for further information about these authentication and encryption options.
readview - Defines the view for read access. (1-32 characters)
writeview - Defines the view for write access. (1-32 characters)
notifyview - Defines the view for notifications. (1-32 characters)
Default Setting
Default groups: public
1
(read only), private
2
(read/write)
readview - Every object belonging to the Internet OID space (1).
writeview - Nothing is defined.
notifyview - Nothing is defined.
Command Mode
Global Configuration
Command Usage
• A group sets the access policy for the assigned users.
• When authentication is selected, the MD5 or SHA algorithm is used as specified in the
snmp-server user command.
• When privacy is selected, the DES 56-bit algorithm is used for data encryption.
• For additional information on the notification messages supported by this switch, see the
Brocade 6910 Ethernet Access Switch MIB Reference. Also, note that the authentication,
link-up and link-down messages are legacy traps and must therefore be enabled in conjunction
with the snmp-server enable traps command.
Example
Console(config)#snmp-server group r&d v3 auth write daily
Console(config)#
1. No view is defined.
2. Maps to the defaultview.