User guide

1050 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Domain Name Service
45
• If all name servers are deleted, DNS will automatically be disabled. This is done by disabling
the domain lookup status.
Parameters
These parameters are displayed:
• Name Server IP Address – Specifies the IPv4 or IPv6 address of a domain name server to use
for name-to-address resolution. Up to six IP addresses can be added to the name server list.
Interface
To create a list name servers:
1. Click IP Service, DNS.
2. Select Add Name Server from the Action list.
3. Enter one name server at a time.
4. Click Apply.
FIGURE 344 Configuring a List of Name Servers for DNS
To show the list name servers:
1. Click IP Service, DNS.
2. Select Show Name Servers from the Action list.
FIGURE 345 Showing the List of Name Servers for DNS