User guide

1046 Brocade 6910 Ethernet Access Switch Configuration Guide

53-1002581-01

Displaying the Routing Table

• The Routing Table (and show ip route command) only displays routes which are currently

accessible for forwarding. The router must be able to directly reach the next hop, so the VLAN

interface associated with a static route entry must be up. Note that routes currently not

accessible for forwarding, may still be displayed by using the show ip route database

command.

Parameters

These parameters are displayed in the web interface:

• VLAN – VLAN identifier (i.e., configured as a valid IP subnet).

• Destination IP Address – IP address of the destination network, subnetwork, or host.

Note that the address 0.0.0.0 indicates the default gateway for this router.

• Net Mask – Network mask for the associated IP subnet. This mask identifies the host address

bits used for routing to specific subnets.

• Next Hop – The IP address of the next hop (or gateway) in this route.

• Metric – Cost for this interface. (Not applicable for current phase.)

• Protocol – The protocol which generated this route information. (Options: Local, Static)

Interface

To display the routing table:

1. Click IP, Routing, Routing Table.

FIGURE 340 Displaying the Routing Table