User guide

996 Brocade 6910 Ethernet Access Switch Configuration Guide
53-1002581-01
Connectivity Fault Management
42
Displaying Local MIPs
Use the Administration > CFM > Show Information (Show Local MIP) page to show the MIPs on this
device discovered by the CFM protocol. (For a description of MIPs, refer to the Command Usage
section under “Configuring CFM Maintenance Domains” on page 977.)
CLI References
• “show ethernet cfm maintenance-points local” on page 537
Parameters
These parameters are displayed:
• MD Name – Maintenance domain name.
• Level – Authorized maintenance level for this domain.
• MA Name – Maintenance association name.
• Primary VLAN – Service VLAN ID.
• Interface – Physical interface of this entry (either a port or trunk).
Interface
To show information for the MIPs discovered by the CFM protocol:
1. Click Administration, CFM.
2. Select Show Information from the Step list.
3. Select Show Local MIP from the Action list.
FIGURE 304 Showing Information on Local MIPs