Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 77 of 79
Defect ID: DEFECT000324507 Technical Severity: Medium
Summary: Router cannot install a router LSA with more than 8304 bytes LSA size and generate a
checksum error resulting in the OSPF neighbor staying in LOADING state.
Probability: Medium
Feature: OSPF Function: OSPF
Reported In
Release:
FI 07.2.00 Service Request ID: 265202
Defect ID: DEFECT000326611 Technical Severity: High
Summary: Executing "dm pp-interrupts counters" command with any device number causes an FESX
to reload.
Workaround: This is a diagnostic command not to be used under normal operating conditions.
Probability: High
Feature: SX_SYSTEM Function: UNDETERMINED
Reported In
Release:
FI 07.2.00 Service Request ID: 268470
Defect ID: DEFECT000327840 Technical Severity: High
Summary: CPU usage is high due to the next-hop-ip running out of resources.
Feature: SX Layer 3 Forwarding - IPV4 and IPV6 Function: Data Forwarding
Reported In
Release:
FI 07.1.00
Defect ID: DEFECT000328563 Technical Severity: Medium
Summary: After increasing the system max parameter “system-max hw-ip-route-tcam”, the error
message “There is insufficient hardware resource for binding the ACL 100 to interface v1”
may be displayed when trying to rebind an ACL.
Probability: Medium
Feature: FCX ACL Function: ACL(all aspects of ACLs - IPV4)
Reported In
Release:
FI 07.2.00
Defect ID: DEFECT000328635 Technical Severity: Medium
Summary: 802.1x per-user ACL cannot be installed if enable password is set and serial console CLI is
not in privileged mode.
Symptom: If enable super-user password is configured on the FWS, and also the serial console CLI is
not in privileged mode, the switch cannot install the per-user ACL that was received from
the RADIUS server in an access-accept message.
Probability: Medium
Feature: FCX ACL Function: 802.1x userbased dynamic policies
Reported In
Release:
FI FGS 04.3.03 Service Request ID: 00268592