Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 76 of 79
Defect ID: DEFECT000321932 Technical Severity: High
Summary: SX router performed a system reset during system bringup and layer 3 protocol
convergence along with reload of neighboring router.
Probability: Low
Feature: SX Layer 3 Forwarding - IPV4 and IPV6 Function: Data Forwarding
Reported In
Release:
FI 07.2.00
Defect ID: DEFECT000321950 Technical Severity: High
Summary: A 48-port FWS or FGS can be made to continuously flood known unicast frames out of all
ports.
Symptom: A 48-port FWS or FGS can be made to continuously flood known unicast frames out of
multiple ports. Even though a MAC address appears in output of "show mac" command,
frames addressed to that MAC address are flooded out of multiple ports.
Workaround: Execute "clear mac <address>" against the specific destination MAC address of the
flooded frames.
Probability: High
Feature: FCX L2 Forwarding Function: MAC Table/FDB Manager
Reported In
Release:
FI 07.2.00 Service Request ID: 258207
Defect ID: DEFECT000322572 Technical Severity: Medium
Summary: Setting port speed to 100-full will not take effect unless the switch is reloaded (FESXHF
Only).
Probability: High
Feature: SX Layer1 features Function: Auto Negotiation
Reported In
Release:
FI 07.2.00 Service Request ID: 263600
Defect ID: DEFECT000324371 Technical Severity: Medium
Summary: FCX management port does not reply to IPv6 neighbor advertisement.
Symptom: Unable to ping FCX IPv6 address after issuing the ‘clear ipv6 neighbor' CLI command.
Workaround: FCX needs to initiate the pingv6 command to other device.
Probability: High
Feature: FCX Layer 3 Forwarding - IPV4 and IPV6 Function: Data Forwarding
Reported In
Release:
FI 07.2.00 Service Request ID: 266516