Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 72 of 79
Defect ID: DEFECT000364076 Technical Severity: High
Summary: ARP request is not forward between Primary and Isolated VLANs.
Symptom: When Private VLANs are configured, an ARP request is not forward between the Primary
and Isolated VLANs.
Probability: High
Feature: FCX L2 Forwarding Function: Private VLAN
Reported In
Release:
FI 07.2.02 Service Request ID: 650833
Defect ID: DEFECT000364534 Technical Severity: Medium
Summary: When the Master unit of a stack is powered off, the ARP entries that are bound to ports on
that unit are not updated even though the MAC entries are updated correctly.
Symptom: FCX fails to transmit L3 routing packet when the stack's Master unit is powered off. 'show
arp' shows a port on the old Master unit which is now inactive.
Workaround: 1) Issue clear arp.
2) Do a switchover between Active and Standby by CLI and then power off the new
Standby (old Active).
Probability: High
Feature: FCX Layer 3 Forwarding - IPV4 Function: Data Forwarding (IPV4)
Reported In
Release:
FI 07.2.02 Service Request ID: 658785
Defect ID: DEFECT000365673 Technical Severity: Medium
Summary: ARP request is not received from host directly connected to a 48 port line module.
Symptom: Cannot ping SX router from a PC that is directly connected to a 48 port line card.
Probability: High
Feature: SX Layer 3 Forwarding - IPV4 Function: Data Forwarding (IPV4)
Reported In
Release:
FI 07.2.02 Service Request ID: 646649
Defect ID: DEFECT000365696 Technical Severity: High
Summary: A Layer 2 Multicast Client may not be able to receive a multicast stream when PIM Dense
Mode is configured.
Symptom: When FCX is running PIM Dense Mode, some Layer 2 receivers may not receive the data.
Probability: Medium
Feature: FCX L2/L3 Multicast Features Function: PIM Dense
Reported In
Release:
FI 07.2.02