Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 7 of 79
Summary of enhancements in IronWare release R07.2.02
This section lists the enhancements in software release 07.2.02.
Summary of enhancements in FSX R07.2.02
Table 1 lists the enhancements in software release 07.2.02 for FESX, SuperX, and FSX devices.
Table 1 Enhancements in FSX R07.2.02
Feature Description Refer to the FastIron
Configuration Guide, section
entitled...
PoE firmware upgrade via CLI You can install PoE firmware from the TFTP
server on a FastIron switch with the CLI
command.
“Installing PoE Firmware”
Hitless support for FSX 800 and
FSX 1600 devices:
• PBR
• GRE Tunnels
• IPv6 to IPv4 Tunnels
This release adds support for PBR, GRE, IPv6 to
IPv4 Tunnels and PBR over GRE.
Configured PBR, GRE, or IPv6 to IPv4 Tunnels
will operate in a hitless manner on FSX 800 and
FSX 1600 devices only.
“Hitless management on the FSX
800 and FSX 1600”
Multi-range VLANs The multi-range VLAN feature allows you to use
a single command to create and configure
multiple VLANs.
“Multi-range VLAN”
DHCP Server All FastIron devices can be configured to
operate as a DHCP server. A DHCP server
allocates IP addresses for a specified period of
time (known as a lease) and manages the IP
address pools and the binding (leased
addresses) databases.
“DHCP Server”
New SNMP MIBs SNMP MIB support has been added for the
following features:
• 802.1x authentication
• Support for MIBs in RFC 2932, RFC 2933
and RFC 2934
• Power Over Ethernet MIB with the
following tables:
• snAgentPoeGbl
• snAgentPoeModuleTable
IronWare MIB Reference Guide