Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 68 of 79
Defect ID: DEFECT000344380 Technical Severity: Medium
Summary: FCX IP traffic goes to the CPU if it ingresses an IP Subnet VE interface.
Symptom: IP traffic goes to CPU with a VE interface configured on an IP Subnet VLAN, or if the VE is
created first before adding ports to the VLAN.
Probability: High
Feature: FI L2 Function: Forwarding - VLAN Manager
Reported In
Release:
FI 07.3.00 Service Request ID: 646619
Defect ID: DEFECT000345298 Technical Severity: High
Summary: IPv6 functionality is dependent only on HW EPROM licensing even if the system is upgraded
via SW Licensing.
Symptom: Although IPv6 commands are configurable on a system that is upgraded via SW Licensing, a
directly connected IPv6 neighbor is not reachable.
Probability: High
Feature: SX Layer 3 Forwarding - IPV6 Function: Host Networking stack (IPV6)
Reported In
Release:
FI 07.3.00 Service Request ID: 640715
Defect ID: DEFECT000347484 Technical Severity: High
Summary: Memory leak may be observed when Policy Based Routing is configured.
Symptom: When Policy Based Routing is dynamically configured or removed from the configuration,
the memory consumption may increase continuously, eventually leading to a system reset.
Probability: High
Feature: FI L3 Unicast Function: Forwarding – PBR
Reported In
Release:
FI 07.3.00 Service Request ID: 672437
Defect ID: DEFECT000353729 Technical Severity: Medium
Summary: FastIron switches may not respond to ICMPv6 echo request.
Symptom: FESX, FCX and FGS switches may fail to reply to ICMPv6 echo request sent by router or IPV6
server (Linux) that is directly connected to the switch.
Probability: High
Feature: FCX Layer 3 Forwarding - IPV6 Function: Data Forwarding (IPV6)
Reported In
Release:
FI 07.2.02 Service Request ID: 611321