Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 60 of 79
Defect ID:
DEFECT000351270
Technical Severity:
High
Summary:
When an FCX stack is reloaded, the Standby unit may reset unexpectedly.
Symptom:
When an FCX stack is reloaded or if the power cord to the Active unit is removed while the stack is
up, the Standby unit may experience an unexpected reset.
Probability:
Low
Risk of Fix:
Low
Feature:
FCX L2 Forwarding
Function:
MAC Table/FDB Manager
Reported In Release:
FI 07.3.00
Service Request ID:
690585
Defect ID:
DEFECT000351317
Technical Severity:
High
Summary:
When a switchover is done on SX, trace messages appear on the console as a result of CPU buffers not
being freed.
Symptom:
When a switchover is done on SX, during Active to Standby management module synchronization,
trace messages appear on the console as a result of CPU buffers not being freed.
Probability:
Low
Risk of Fix:
Low
Feature:
FI Infrastructure
Function:
SX Hitless Failover
Reported In Release:
FI 07.3.00
Service Request ID:
683651
Defect ID:
DEFECT000354876
Technical Severity:
Low
Summary:
"show version" truncates the full binary image name on non-active units.
Symptom:
If a long image name or a long TFTP server directory path is used, a truncated rather than full name is
shown on the Standby and member units' flash partitions when "show version" is issued.
Probability:
Medium
Risk of Fix:
Medium
Feature:
FCX Management Functionality
Function:
CLI and parser
Reported In Release:
FI 07.3.00
Service Request ID:
686721
Defect ID:
DEFECT000361448
Technical Severity:
Medium
Summary:
IP Default Route's hardware entry is not updated although the software entry is updated after failover.
Symptom:
If the configured Static Default Route is deleted after a failover and the best default route is now
through OSPF, the OSPF route is updated in software but not in hardware.
Probability:
High
Risk of Fix:
Medium
Feature:
FI L3 Unicast
Function:
Forwarding - SX v4
Reported In Release:
FI 07.3.00
Defect ID:
DEFECT000362369
Technical Severity:
Medium
Summary:
Spanning Tree states of ports of a single LACP trunk are different after a hitless failover on FCX
stack.
Symptom:
If Spanning Tree is disabled on an LACP trunk, after hitless failover on the FCX stack, Spanning Tree
state of the primary port is shown correctly as "OFF", but is shown incorrectly as "ON" for all the
member ports.
Workaround:
Disable Spanning Tree for the relevant trunk ports inside the VLAN configuration instead of
disabling directly on the ports.
Probability:
Medium
Feature:
FCX L2 Control
Function:
LinkAggregation - LACP/Dynamic
Reported In Release:
FI 07.2.02
Service Request ID:
645709