Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 58 of 79
Customer reported defects closed with code in Release R07.2.02f
Defect ID:
DEFECT000315704
Technical Severity:
High
Summary:
VE interface's line protocol remains up even if interface itself is not.
Symptom:
The outputs of "show ip interface" and "show interface ve" display a given VE's line protocol as 'Up'
even though the interface is not enabled.
Probability:
High
Risk of Fix:
Medium
Feature:
FCX Layer 3 Forwarding - IPV4 and IPV6
Function:
Virtual interface (ve) Manager
Reported In Release:
FI 07.1.00
Service Request ID:
259859
Defect ID:
DEFECT000328636
Technical Severity:
Medium
Summary:
Boot code cannot be upgraded when using only an IPv6 address.
Symptom:
If an IPv6 address is used for upgrading the boot code, the TFTP request is not sent from the Switch,
resulting in a TFTP timeout error. As a result the boot code cannot be upgraded.
Workaround:
Use IPv4 for upgrading the boot code.
Probability:
High
Risk of Fix:
Low
Feature:
SX_SYSTEM
Function:
UNDETERMINED
Reported In Release:
FI 07.2.00
Service Request ID:
269493
Defect ID:
DEFECT000331756
Technical Severity:
Medium
Summary:
OSPF point-to-point is configurable on a VE even though it is not supported.
Symptom:
The command "ip ospf network point-to-point" is accepted for virtual interfaces via CLI even though
it is not supported, and yields unpredictable results.
Probability:
High
Risk of Fix:
Low
Feature:
OSPF
Function:
OSPF
Reported In Release:
FI 07.2.00
Service Request ID:
269910
Defect ID:
DEFECT000333308
Technical Severity:
High
Summary:
Configuring inline power on a port of a non-PoE FGS switch will cause the system to reset.
Symptom:
On a non-PoE FGS switch, configuring "inline power" on a port that is disabled or disconnected
causes the switch to reset immediately.
Probability:
High
Feature:
Power over Ethernet
Function:
Power over Ethernet
Reported In Release:
FI 07.2.02
Service Request ID:
666731 651017 695411
Defect ID:
DEFECT000333939
Technical Severity:
Medium
Summary:
Access-list to permit/deny ICMP with certain types does not work.
Symptom:
Access list does not honor different types of ICMP packets in transit traffic if the access-list also
contains filters for TCP ports. All ICMP types will be permitted or denied.
Workaround:
Do not apply filter with TCP ports in addition to ICMP types.
Probability:
Low
Risk of Fix:
Low
Feature:
SX ACL
Function:
ACL(all aspects of ACLs - IPV4)
Reported In Release:
FI 07.2.00
Service Request ID:
514363