Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 56 of 79
Defect ID:
DEFECT000396159
Technical Severity:
Low
Summary:
RADIUS IP Address may be displayed incorrectly in the output of “show table-mac-vlan detail”
command.
Symptom:
In the "show table-mac-vlan detail" display, not enough characters are allocated for the RADIUS IP
address column, which can cause trailing characters to be lost for a given IP address.
Probability:
Medium
Feature:
FCX L2 Forwarding
Function:
MAC- BASED VLAN
Reported In Release:
FI 07.2.02
Service Request ID:
722235
Defect ID:
DEFECT000396545
Technical Severity:
Medium
Summary:
Aggregate VLAN Q-in-Q supports frame sizes of up to 1522 bytes only.
Symptom:
With Q-in-Q configured, frame sizes of up to 1522 bytes are supported instead of the expected 1530
bytes. Frames larger than 1522 bytes are dropped.
Workaround:
Configure for Jumbo frame support.
Probability:
High
Feature:
FCX L2 Forwarding
Function:
Q-in-Q
Reported In Release:
FI 07.2.02
Service Request ID:
715413
Defect ID:
DEFECT000397889
Technical Severity:
High
Summary:
Configuring and then removing Protocol VLAN does not clear the MAC Address Locking settings on
port registers.
Symptom:
High CPU condition due to data packets being forwarded by the CPU instead of in the hardware.
Workaround:
Issue "dot1x-enable", followed by "no dot1x-enable".
Probability:
Medium
Feature:
SX L2 Forwarding
Function:
Protocol VLAN
Reported In Release:
FI 07.2.02
Service Request ID:
725439
Defect ID:
DEFECT000398642
Technical Severity:
High
Summary:
Switch may reset when printing debug messages to all destinations under certain conditions.
Symptom:
The switch may experience a reset if Telnet password is enabled and the “debug destination all”
command is used to send debug output to all connected sessions.
Probability:
High
Feature:
FI Embedded Management
Function:
CLI Parser
Reported In Release:
FI 07.4.00
Service Request ID:
724131
Defect ID:
DEFECT000399298
Technical Severity:
Medium
Summary:
IP Cache display shows incorrect VLAN IDs for some entries.
Symptom:
In rare cases, the output of the "show ip cache" command displays IP Address entries with incorrect
VLAN IDs.
Probability:
Low
Feature:
FCX Layer 3 Forwarding - IPV4
Function:
Data Forwarding (IPV4)
Reported In Release:
FI 07.2.02
Service Request ID:
683131