Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 55 of 79
Defect ID:
DEFECT000392006
Technical Severity:
Medium
Summary:
MIB OID snAgentPoePortWattage does not return the configured value.
Symptom:
The power limit on a PoE port can be set via SNMP and the value is configured correctly on the port,
but it cannot be read and always displays the power value as 0 using the snAgentPoePortWattage MIB
OID.
Probability:
High
Feature:
FCX Network Management
Function:
SNMP V4/V6
Reported In Release:
FI 07.3.00
Service Request ID:
696861
Defect ID:
DEFECT000392506
Technical Severity:
Medium
Summary:
Hardware MAC entries are not properly deleted after aging, increasing the probability of MAC hash
collisions.
Symptom:
Over a long period of time on a campus network with many mobile users logging in an out constantly,
some users lose Layer 2 connectivity as their MAC addresses cannot be learned.
Workaround:
Clearing the ARP cache usually resolves the problem. If it does not, reload the Switch/Router
during a maintenance window.
Probability:
Medium
Feature:
FCX L2 Forwarding
Function:
MAC Table/FDB Manager
Reported In Release:
FI 07.2.00
Service Request ID:
712255
Defect ID:
DEFECT000394040
Technical Severity:
Medium
Summary:
CPU memory usage increases constantly when using OpenNMS tool to poll system IP addresses.
Symptom:
If OpenNMS tool is used to poll the IP addresses on a system, it can cause a CPU heap memory leak
over time due to terminating multiple SSH connections prematurely.
Workaround:
Use Telnet instead of SSH to access the device.
Probability:
High
Feature:
SX Management Functionality
Function:
IPv4/V6 SSH Service
Reported In Release:
FI 07.2.02
Service Request ID:
704159
Defect ID:
DEFECT000395770
Technical Severity:
Medium
Summary:
Using the Web Management interface to add ports to VLAN may cause MRP ring-interfaces to be
removed from configuration.
Symptom:
MRP ring Interfaces disappear from the configuration when an unrelated port is added to or removed
from the VLAN via Web Management interface.
Workaround:
Use the CLI to make the changes.
Probability:
Medium
Feature:
FCX Network Management
Function:
Web Management
Reported In Release:
FI 07.3.00
Service Request ID:
722273
Defect ID:
DEFECT000396100
Technical Severity:
Medium
Summary:
Switch with no IPv4 address configured generates ARP packets incorrectly when both a Management
VLAN and Uplink Switch are configured.
Symptom:
Switch with no IPv4 address configured generates ARP packets with Source Address 0.0.0.0 for
directed broadcast traffic when both a Management VLAN and Uplink Switch are configured.
Probability:
High
Feature:
SX Layer 3 Forwarding - IPV4
Function:
Data Forwarding (IPV4)
Reported In Release:
FI 07.2.02
Service Request ID:
722675