Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 49 of 79
Customer reported defects closed with code in Release R07.2.02h
Defect ID:
DEFECT000347917
Technical Severity:
Medium
Summary:
FCX device does not forward ARP broadcast packets when raw packet debugging is enabled.
Symptom:
When the "dm raw packet debugging" command is executed in a Telnet console, the incoming ARP
broadcast packets may not be forwarded in FCX devices.
Workaround:
Turn off "dm raw".
Probability:
Medium
Feature:
FCX Layer 3 Forwarding - IPV4
Function:
Data Forwarding (IPV4)
Reported In Release:
FI 07.2.02
Service Request ID:
266738
Defect ID:
DEFECT000351893
Technical Severity:
High
Summary:
Memory usage steadily increases occurs every time a Web Authentication client logs in and logs out
using HTTPS.
Symptom:
Memory is constantly depleted every time a Web Authentication client logs in and logs out using
HTTPS.
Workaround:
Reboot the device.
Probability:
High
Risk of Fix:
Medium
Feature:
FI - L4/Security
Function:
Web Authentication
Reported In Release:
FI 07.3.00
Service Request ID:
700759
Defect ID:
DEFECT000361556
Technical Severity:
Critical
Summary:
System unexpectedly reload in ARP function during hitless-failover.
Symptom:
FastIron devices may go for reset during hitless failover sometimes.
Risk of Fix:
Low
Feature:
FI L3 Unicast
Function:
Forwarding - FX v4
Reported In Release:
FI 07.3.00
Service Request ID:
745347
Defect ID:
DEFECT000402207
Technical Severity:
Medium
Summary:
Switch reports 1 in snmpget for IF-MIB::ifOperStatus when the port is down.
Symptom:
IF-MIB::ifOperStatus when polled by SNMP may return incorrect status for 10G physical port.
Workaround:
Upgrade code
Probability:
Medium
Feature:
SX Network Management
Function:
SNMP V4/V6
Reported In Release:
FI 07.2.02
Service Request ID:
691215
Defect ID:
DEFECT000404397
Technical Severity:
Medium
Summary:
Printing more than 700 lines at a time in buffer logging, causes high CPU. VRRP might not process
control packets.
Symptom:
High CPU may be noticed in SX device when the “logging buffer 1000” command is executed and
more than 700 lines are to be logged in SYSLOG.
Workaround:
Remove the "logging buffer" from the configuration. Default is 50 lines.
Probability:
High
Feature:
SX Network Management
Function:
SYSLOG
Reported In Release:
FI 07.2.02
Service Request ID:
721885