Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 44 of 79
UNIT 3: SL 1: FCX-24GS POE 24-port Management Module
Serial #: BCW22926209
License: FCX_ADV_ROUTER_SOFT_PACKAGE (LID: )
P-ENGINE 0: type DB90, rev 01
==========================================================================
UNIT 3: SL 2: FCX-2XGC 2-port 16G Module (2-CX4)
==========================================================================
UNIT 3: SL 3: FCX-2XG 2-port 10G Module (2-XFP)
==========================================================================
UNIT 4: SL 1: FCX-24GS 24-port Management Module
Serial #: BCV2223F001
License: FCX_ADV_ROUTER_SOFT_PACKAGE (LID: )
P-ENGINE 0: type DB90, rev 01
==========================================================================
UNIT 4: SL 2: FCX-2XGC 2-port 16G Module (2-CX4)
==========================================================================
UNIT 5: SL 1: FCX-24GS 24-port Management Module
Serial #: BCV2223F022
License: FCX_ADV_ROUTER_SOFT_PACKAGE (LID: )
P-ENGINE 0: type DB90, rev 01
==========================================================================
UNIT 5: SL 2: FCX-2XGC 2-port 16G Module (2-CX4)
==========================================================================
800 MHz Power PC processor 8544E (version 33/0022) 400 MHz bus
65536 KB flash memory
256 MB DRAM
Monitor Option is on
STACKID 1 system uptime is 1 minutes 54 seconds
STACKID 2 system uptime is 1 minutes 54 seconds
STACKID 3 system uptime is 1 minutes 54 seconds
STACKID 4 system uptime is 1 minutes 54 seconds
STACKID 5 system uptime is 1 minutes 54 seconds
The system started at 09:07:46 GMT+09 Tue Feb 08 2011
The system : started=warm start reloaded=by "reload"
My stack unit ID = 1, bootup role = active
telnet@fcx648s-upper#
NOTE: If any unit in the IronStack is running an incorrect version of the software, it will appear as non-
operational. You must install the correct software version on that unit for it to operate properly in the
stack. For more information, refer to section “Copying the flash image to a stack unit from the Active
Controller” in the FastIron Configuration Guide.
Technical support
Contact your switch supplier for the hardware, firmware, and software support, including product
repairs and part ordering. To expedite your call, have the following information immediately available:
1. General Information
• Technical Support contract number, if applicable
• Device model
• Software release version
• Error numbers and messages received
• Detailed description of the problem, including the switch or network behavior immediately
following the problem, and specific questions