Technical data

IronWare Software Release 07.2.02j for Brocade FastIron switches
Release Notes v 1.0 Page 12 of 79
The following table describes the information displayed by the show sntp associations command.
Table 4 Output from the show sntp association command
Field Description
(leading character) One or both of the following:*Synchronized to this peer ~Peer is
statically configured
address IP address of the peer
ref clock IP address of the peer reference clock, or the reference ID of the
external clock source if the peer is stratum 1.
Examples of external clock source IDs: GPS, CDMA, WWV (Ft.Collins
US Radio 2.5, 5, 10, 15 MHz), CESM (calibrated Cesium clock), etc.
st NTP stratum level of the peer
when Amount of time since the last NTP packet was received from the peer.
A negative number indicates the system has never received any
synchronization message from the specified server.
poll The poll interval of the peer relative to the server.
delay The total delay time in milliseconds along the path to the root clock.
disp The dispersion of the root path in milliseconds.
To display detailed information about SNTP associations, enter the show sntp associations details
command.
Brocade# show sntp associations details
208.99.8.95 configured,insane, unsynched,invalid, stratum 16
ref ID 0.0.0.0,time 0.0 (Jan 1 00:00:00)
our mode client, peer mode unspec, our poll intvl 15, peer poll intvl 0
root delay 0.0 msec, root disp 0.0
delay 0 msec, offset 0 msec
precision 2**0, version 0
org time 0.0 (Jan 1 00:00:00)
rcv time 0.0 (Jan 1 00:00:00)
xmt time 0.0 (Jan 1 00:00:00)
Syntax: show sntp associations details
The following table describes the information displayed by the show sntp associations details
command.
Table 5 Output from the show sntp associations details command
Field Description
IP address The IP address of the SNTP server. The IP address is an IPv4 or an IPv6
address.
configured or dynamic The SNTP server is either configured, or the last responsive broadcast
server that is found dynamically.