Installation guide

74 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1002500-01
Testing network connectivity
3
FIGURE 44 CX4 transceiver cable
Testing network connectivity
After you install the network cables, you can test network connectivity to other devices by pinging
those devices. You also can observe the LEDs related to network connection and perform trace
routes.
For more information about ping and traceroute commands, refer to the FastIron Configuration
Guide
Observing LEDs
After you install the network cables, you can observe certain LEDs to determine if the network
connections are functioning properly. Table 22 outlines the LEDs related to the network
connections, the desired state of each LED, possible abnormal states of each LED, and what to do
if an LED indicates an abnormal state.
NOTE
Some modules use combined link and activity LEDs.
1CX4 transceiver cable
1