Installation guide

54 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1002500-01
Powering on the system
2
Connecting AC power to the chassis
AC power is supplied though an AC power cord that is connected to the back of the chassis. Perform
the following tasks to connect AC power to the chassis.
1. At the rear of the chassis, locate the power receptacles on the power supplies.
2. Lift the cord-retainer and connect a Brocade-supplied AC power cord to the power supply.
3. Snap the cord-retainer over the power plug to hold it in place, as illustrated in Figure 35.
FIGURE 35 Connecting the AC power cord on an FSX 800 device
1Cord retainer
AC1
AC2
AC3
AC4
1