Installation guide

18 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1002500-01
Hardware features
1
FIGURE 10 IPv6 24-port Gigabit Ethernet copper module front panel
The front panel includes the following control features:
• 24 10/100/1000 copper ports
• 24 LEDs for port status
• 24 LEDs for PoE status
NOTE
The PoE LEDs work only when PoE is enabled on your device.
LEDs for 24-port copper module
The front panel of the 24-port Gigabit Ethernet copper module includes 24 LEDs (top) that indicate
the status of each port, and 24 LEDs (bottom) that indicate the PoE status.
NOTE
The PoE LEDs work only when PoE is enabled on your device.
The copper ports provide status information using the LEDs described in Table 10.
24-port Gigabit Ethernet copper module with PoE+
The 24-port Gigabit Ethernet copper interface module with PoE+ supports both IPv4 and IPv6.
Figure 11 shows the front panel of the IPv4 and IPv6 24-port Gigabit Ethernet copper interface
module with PoE+. The module requires Ironware 7.3 or later for FastIron series.
1 Port 1 13 Port 13 24 Port 24
2Port 2 14Port 14
TABLE 9 LEDs for 10/100/1000 copper ports
LED Position State Meaning
Link or Activity Square LED located at upper left
corner of to port (for top port)
Square LED located at upper right
corner of top port (for bottom
port)
On (Green) A link is established with the remote port.
Blinking The port is transmitting and receiving traffic.
Off No link exists with the remote port.
PoE (if
applicable)
Round LED located beneath the
ports. The first (left-most) LED is
for port 1, the second LED is for
port 2, the third LED is for port 3,
etc.
On (Green) The port is enabled, a power-consuming
device has been detected, and the module is
supplying power to the device.
Off The port is not providing in-line power.
624C
2
14 24
1
13
3