Installation guide

12 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1002500-01
Hardware features
1
10-GbE ports on the FSX 800 and FSX 1600 2-port 10-GbE management modules
FSX 800 and FSX 1600 2-port 10-GbE management modules contain two 10-GbE fiber ports
through which you can connect your device to other network devices at a speed of 10 Gigabits per
second.
The 10-GbE ports have optical interfaces with LC connectors for 10-Gigabit Small Form Factor
Pluggable (XFP) MSA-compliant transceivers. The transceivers support the fiber optic cabling for
LAN PHY listed in Table 34 on page 151.
LEDs on the FSX 800 and FSX 1600 management modules
The management modules provide status information through the LEDs listed in Table 5.
Console port
The Console port on the management module is a standard DB-9 serial connector through which
you can attach a PC or terminal to configure the system using the command line interface (CLI).
The Console port interfaces with the control plane only and does not interface with the data plane.
Reset button
The reset button on the management module allows you to restart the system. The reset button is
recessed to prevent it from being pushed accidentally.
The reset button is located next to the console port on the management module.
TABLE 5 FSX 800 and FSX 1600 management module LEDs
LED Description and Position State Meaning
Pwr Round LED located to the left of the
console port
On (Green) The module is receiving power.
Off The module is not receiving power.
Active Round LED located to the left of the
console port
On (Green) The module is the active management
module.
Off The module is not the active management
module.
10/100/1000 Copper Port LEDs
Lnk Left-most LED above the port On The port is connected.
Off No port connection exists.
Act Right-most LED above the port. On or Blinking The port is transmitting and receiving traffic.
Off The port is not transmitting or receiving
traffic.
10-GbE Port LEDs
Lnk Top-most LED to the left of the port. On Fiber port is connected.
Off No fiber port connection exists.
Act Bottom-most LED to the left of the
port.
On or Blinking The port is transmitting and receiving traffic.
Off The port is not transmitting or receiving
traffic.