Installation guide

128 Brocade FastIron SX Series Chassis Hardware Installation Guide

53-1002500-01

Installing or replacing a power supply

6. Carefully remove the power supply from the chassis.

7. Install a new power supply in the slot. For information about performing this task, refer to

“Installing a new power supply” on page 128.

Installing a new power supply

You can order a new power supply from Brocade Communications, Inc..

The procedures for installing a power supply differ depending on the power supply type

(replacement or original). Be sure to refer to the appropriate procedures in this section. For the

differences between replacement and original power supplies, refer to “Replacement power

supplies” on page 31.

DANGER

Before beginning the installation, refer to the precautions in “Power precautions and warnings”

on page 39.

Installing a replacement power supply

For an overview of replacement power supplies (part numbers 32014-xxx and 32016-xxx), refer to

“Replacement power supplies” on page 31.

To install a replacement power supply, you need a Phillips-head or flathead screwdriver.

The following illustration shows the replacement power supplies.

To install a replacement power supply, perform the following tasks.

1. Use a Phillips-head or flathead screwdriver to loosen the latch screw in the front upper right

corner of the power supply. Once the screw is loosened, the latch will spring gently forward and

down.

2. Insert the new power supply into the empty power supply slot as shown in Figure 59.

1 Latch retaining screw

2 Latch retaining screw

SYS

POE