Installation guide

Brocade FastIron SX Series Chassis Hardware Installation Guide 119
53-1002500-01
Installing or replacing a POE daughter card
6
FIGURE 54 POE daughter card
• Insert the POE daughter card into the connector slot on the 24-port module as shown in
Figure 55.
FIGURE 55 Installing the POE daughter card
5. Re-assemble the device:
• Gently slide the module back into the chassis until the ejectors on both sides of the
module move close to the module front panel.
• Push the ejectors in towards the center of the module. This action will fully seat the
module in the backplane.
• Use a #2 Phillips-head or flathead screwdriver to tighten the two screws at both ends of
the module front panel.
6. Observe the console. The following message will appear.
1POE daughter card
2Line card
1
2