Installation guide

118 Brocade FastIron SX Series Chassis Hardware Installation Guide
53-1002500-01
Installing or replacing a POE daughter card
6
• Pull the card ejectors on the 24-port module toward you and away from the module front
panel. This action unseats the module from the backplane.
• Slide the module out of the chassis and place it on a static-free work area.
3. If you are replacing the POE daughter card, remove the existing card from the connector slots
on the 24-port module. Figure 55 shows the location of the POE daughter card.
4. Install the new POE daughter card:
• Locate the connector slots for the POE daughter card on the 24-port module (refer to
Figure 53).
FIGURE 53 Connector slots for POE daughter card
• Remove the POE daughter card from its packaging. The POE daughter card is keyed to
prevent improper insertion, as shown in Figure 54.
1 Connector slots
1