Network Router User Manual

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 55
53-1001931-01
Common commands
2
Syntax (Global Config Mode) (Global Config)
service [advanced-vty|dhcp|diag|password-encryption|pm|
prompt|radius|redundancy|set|show|terminal-length|
watchdog]
service [advanced-vty|dhcp|watchdog]
service diag [enable|limit|period|tech-support-period|
tech-support-url]
service password-encryption secret 2 <pass-phrase>
service pm sys-restart
service prompt crash-info
service radius {restart}
service redundancy dynamic-ap-load-balance start
service set [command-history|reboot-history|upgrade-history]
<10-100>
service show cli
service terminal-length <0-512>
• enhanced-probe-table [enable|erase-report|max-client|
preferred|window-time] – Enhanced probe table for Client
locationing.
• enable – Enables the Enhanced Probe Table feature for
Client locationing.
• erase-report – Erases the reports for Enhanced Probe
Table feature.
• max-client <0-512> – Sets the maximum clients in the
Enhance Probe Table report.
• preferred <MAC> – Add the MAC <MAC> to the
preferred Client list.
• window-time – Sets the Window Time for probe
collection in seconds to a value in the range 10 to 60
seconds.
• free-packet-watermark – It is free packets threshold. If the
percentage of free packets is lower than this number, then
additional packets will not be queued up in the datapath
• idle-radio-send-multicast – Forward multicast packets to
radios without associated wireless clients
• legacy-load-balance – Invoke legacy load balance algorithm
• map-radios – Set radio-to-cpu mapping constant
• radio-misc-cfg – radio specific misc configuration U16 for all
radios
• rate-scale – Enable wireless rate scaling (default)
• request-ap-log – Request ap Log
• save-ap-log – Saves debug/error logs sent by the
access-point
• snmp-trap-throttle – Limits the number of SNMP traps
generated from the wireless module
• sync-radio-entries – sync radio configuration at cluster levels
• vlan-cache – VLAN-cache mode