Network Router User Manual

Brocade Mobility RFS4000, RFS6000 and RFS7000 CLI Reference Guide 31
53-1001931-01
Chapter
2Common Commands
In this chapter
•Common commands . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31
•show . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 59
This chapter describes the CLI commands used in the USER EXEC, PRIV EXEC, and GLOBAL
CONFIG modes.
The PRIV EXEC command set contains those commands available within the USER EXEC mode.
Some commands can be entered in either mode. Commands entered in either USER EXEC mode or
PRIV EXEC mode are referred to as EXEC mode commands. If a user or privilege is not specified,
the referenced command can be entered in either mode.
Common commands
Table 2.1 summarizes available common commands:
Table 2.1 Common Commands in RFController
Command Description Ref.
clrscr Clears the display screen page 32
exit Ends the current mode and moves to the previous mode page 33
help Displays the interactive help system page 34
no Negates a command or sets its defaults page 35
service Services or debugs the controller page 37
show Shows running system information page 59